Things are much easier and faster if you use AirPort Utility on an iPad.įirst, perform a Hard Reset on the AirPort Extreme by powering it up for a few minutes, then holding in the reset button on the back of the AirPort for 7-8 seconds. Has anyone configured one this way yet and can provide me with some instructions? I have tried searching for instructions, to do exactly what I need, but have found conflicting information (extending wifi, bridging, etc.) and just haven't gotten it to work yet. This is not my area of expertise but I can usually get things working with the help of google and support sites. I moved the netgear out there for a quick test and it worked perfectly so I know my line/connection is good. I need it extending the existing mesh network so it can still seamlessly jump between beacons, routers, etc. I was able to do this with a netgear wifi router, to extend the signal in my garage, but I can't seem to get the extreme to setup properly. I ran CAT6 out into my shop, since my wifi won't pass through the metal walls, at all, and am trying to configure the Extreme so I can hardwire it to my EERO network to extend the wireless mesh network inside my building. Release the button, and AirPort Extreme will reset.I'm trying to use my Airport Extreme to extend my EERO wireless network into my metal shop via ethernet. If your AirPort Extreme has firmware 5.5.1 or later follow these steps:Ĭontinue holding it until you see the center status light (LED) start to flash rapidly, which should happen after about five seconds. Plug back in the Ethernet cable and reconnect to your network. The base station restarts to load the new settings. Unless you have been given an IP address by your ISP or system administrator, do not change the IP address.Ĭlick Update. Or, turn on encryption (WPA2 is recommended) and enter a new password for your AirPort network. To change the network password, choose the Wireless tab and edit the Wireless password field. To reset base station password, choose Base Station tab and edit the password field. You now have the opportunity to change settings such as base station password, network password, the Access Control List, and RADIUS. ![]() Ignore the errors in Base Station Status at this time. Locate and double-click your base station to configure it. ![]() Open the Airport Utility from the Applications : Utilities folder. AirPort will indicate if it's in hard reset mode by blinking faster.įrom the AirPort menu bar item, choose the network created by the base station (the network name does not change). Note: Holding the reset button for 5 seconds or longer will do a hard reset. ![]() If you do not make your changes within five minutes of pressing the reset button, the base station will revert to the previous configuration. The base station remains in reset mode for five minutes. Press and hold the base station reset button for one full second. Select Airport from the list of connections on the left. from the Apple menu at the top left hand corner of the screen.Ĭlick the Network icon to open the Network Preferences. The AirPort Extreme must be connected to power during the following steps.ĭisconnect any Ethernet cables from the base station.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |